Rattler 369D Guide d'installation télécharger pdf (Page 53)

vating the unit with the ignition key in the “run” position. If

the vehicle then runs normally, retest your ignition system.

➤ The starter continues to crank even though the engine has

started.

Has the tach wire been learned? See the Tach Learning

section of this guide.

Is the tach wire receiving the correct information? Either the

wrong tach wire has been used, or a bad connection exists.

➤ The climate control system does not work while the unit is

operating the vehicle.

Either the wrong accessory wire is being energized or more

than one ignition or accessory wire must be energized in

order to operate the climate control system.

➤ The remote start will not activate.

Check harnesses and connections. Make sure the harnesses

are fully plugged into the remote start module. Make sure

there are good connections to the vehicle wiring.

Check voltage and fuses. Use a meter and check for voltage

between the red wire in the 5 pin ribbon harness and the

black ground wire. If you have less than battery voltage,

check the and both 30A fuses on the relay satellite. Also

make sure that the ground wire is going to a chassis ground

and not to something under the dash.

➤ The remote start will activate but the starter never engages.

Check for voltage on the purple starter wire two seconds

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 62 63

Pas de commentaire

Rattler 369D Guide d'installation Page 53