Rattler 369D Guide d'installation télécharger pdf (Page 18)

Now that the accessories have been located, find the wire

suspected to be the starter wire according to the web information

on your vehicle. Place the red lead of your meter on the wire.

With the key in the off position the meter should read 0.00 volts

and will stay at 0.00 volts in all key positions except the crank

position. In the crank position your meter should read between

10.00 volts and 13.00 volts, and will drop back to 0.00 volts

when the starter disengages.

Once you locate the starter wire, cut the wire in half and try to

start the vehicle. If the vehicle does not start, the correct wire has

been identified. Reconnect the starter wire while soldering the

thick VIOLET wire off the relay satellite pack to it and cover the

connection with electrical tape.

step 4

Safety Shutdown Wires

With all ignition wires properly connected, find the appropriate

safety shutdown wires. These include the brake wire, hood pin,

important! These wires are meant to protect the vehicle

and anyone near the vehicle. They must be connected

appropriately to prevent damage to the vehicle and possi-

ble bodily injury. Failure to properly install these wires may

cause the vehicle to lunge if remote started while in gear.

➜

nnoottee::

Always check the Web site information on your

vehicle for warnings regarding the starter wire and check

engine lights. Some vehicles will trip a check engine light

if the starter wire is cut.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 62 63

Pas de commentaire

Rattler 369D Guide d'installation Page 18