Rattler 369D Guide d'installation télécharger pdf (Page 36)

change the settings. It is possible to access and change any of the

feature settings using the Valet/Program switch. To program

settings, remember: Key, Choose, Transmit and Release.

To program the learn routine:

KKeeyy

. Turn the ignition on and then

back off.

CChhoooossee

. Within 10 seconds, press and

release the Valet/Program switch the

number of times corresponding to the

feature number you want to program. (See

Features Menu section.)

Once the Valet/Program switch has been pressed and released

the desired number of times, press it once more and hold it.

After a second, the LED will flash to indicate which feature you

have accessed. For example, groups of eight flashes would indi-

cate access to the status output feature (Feature 8).

TTrraannssmmiitt

. The transmitter is used to

select the desired setting. As shipped, the

unit is configured to the LED ON settings.

These are called the default settings.

Pressing will set it to the LED ON setting. The LED will

light solid (stop flashing) to indicate the setting. Pressing

will change the setting to the LED OFF setting. The LED will

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 62 63

Pas de commentaire

Rattler 369D Guide d'installation Page 36